Perun for M14 Drop-in MOSFET (Tokyo Marui / CYMA)

If you run a Tokyo Marui M14 or one of its clones, the Perun for M14 gives it a proper electronic trigger without hacking the gearbox about. This drop-in airsoft MOSFET replaces the original trigger block with a Perun housing that carries the circuit board and an integrated Clicker. The trigger is read magnetically, while the selector and sector gear are read optically, so there are no contacts left to wear out.

Everything is set up using the selector and trigger, with a multicolour LED to guide you, and SEMI and AUTO can each be configured their own way. The wiring suits a battery in either the stock or the front grip, so it works with the layout you already have.

Key specs

• Fits M14s by Tokyo Marui and clones such as CYMA, G&P and Echo 1
• JG M14s are only partly compatible and need some modification
• Not compatible with G&G or Classic Army M14s
• Gears must be compatible with the M14 V7 gearbox
• Battery: 7–17V, with 7.4V, 11.1V or 14.8V Li-Po or Li-Ion recommended. T-Plug (Deans) fitted
• Firing modes: semi, burst (2–5 shots), auto and binary, plus two-stage semi–burst, semi–auto and burst–auto
• Adjustable Clicker break force, pretravel and overtravel, with 8 trigger sensitivity levels
• Active brake, precocking, DMR mode, rate of fire reduction and DSG mode
• Custom cut-off lever, low-battery alarm, diagnostics and an electronic resettable fuse
• Battery in the stock or front grip
• Warranty: 24 months from retail purchase

Safety note: The Perun for M14 has no electronic safety, so always use the rifle's mechanical trigger lock. It also draws a small current (about 1mA) on safe, so unplug the battery after every game. Full details are in Perun's M14 manual. Need a pack? Take a look at our 7.4v Li-Po batteries.

You may also like

• JG M14 400 Round High Cap Magazine
• SHS Spring Set for V7 Gearbox
• Oper8 11.1v 1500mAh LiPo Stick Battery
• Perun V3 Integrated Drop-in MOSFET