Need your RIF repaired? Check out our tech services!

Electrical Parts & Extras

Your AEG's electrics carry power from the battery to the motor, so worn contacts or poor connectors cost you trigger response and rate of fire. Upgrading them is a cheap way to make your gun snappier and more reliable.

Find wiring, trigger contacts, microswitches, connectors and electrical parts, plus wiring and switch assemblies, MOSFETs and ETUs and battery leads and connectors.

View as

Frequently Asked Questions

Need To know more?

Why upgrade my AEG wiring?

Better wiring and connectors deliver more power to the motor, improving trigger response.

What is a microswitch?

A small electronic switch that gives a very short, crisp trigger pull and protects contacts.

Should I fit a MOSFET?

Yes, especially with LiPo batteries. It protects your trigger contacts and sharpens response.

Can you rewire my gun?

Yes. Our tech team offers rewiring and a connector change service.

AEG Electrical Parts and Gearbox Extras

This collection brings together the electrical components and small gearbox parts that keep an AEG running reliably. Whether you are repairing a worn switch, rewiring for better performance or replacing tired springs and screws, it is often these parts that make the biggest difference to how a gun feels.

Wiring and Switches

Original wiring and trigger contacts can limit current and wear over time. Our range includes ZCI switch block assemblies for V2 and V3 gearboxes in both front-wired and rear-wired versions, Rocket V2 and V3 trigger contacts, and JG wiring looms for V3, P90 and AUG platforms. Rocket also offers a V2 rear wiring loom with mini Tamiya and a high-current Deans set. Gate heatshrink sets help keep your wiring neat and insulated.

Front or rear wired?

Front-wired guns run the wires forward to a battery in the handguard, while rear-wired guns run them to the stock. Make sure you choose the right version, as the two are not interchangeable.

Gearbox Small Parts

You will also find many of the small gearbox parts that wear or get lost during a rebuild: ZCI and Rocket cut-off levers for V2, V3 and V7 gearboxes, gearbox spring sets, standard and stainless screw sets, anti-reversal latches, a metal tappet plate delayer and a sector gear delay chip. E&C offers a reinforced V2 gearbox shell, and EPES a gearbox O-ring set. SHS replacement motor brushes can extend the life of a worn motor.

Triggers and Selectors

Tuneable triggers such as the Speed M28 and Prometheus Sigma trigger for Next Gen Recoil guns, along with a Strike M4 HPA/microswitch speed trigger, let you shorten or adjust trigger pull. JG selector levers and gears are available for several models too.

Common Signs Something Needs Replacing

A gun that fires intermittently, hesitates on the trigger or feels slow can point to burnt trigger contacts, loose wiring or a worn connector. Unusual noises or a gun that won't cycle properly can point to a gearbox issue, while a selector that won't engage properly can mean a worn cut-off lever or selector plate. Replacing these small parts is often an inexpensive way to restore a gun's performance.

Tips Before You Start

Always disconnect the battery before working on wiring, and confirm your gearbox version and wiring direction before ordering. Many players fit a MOSFET or ETU when rewiring to protect trigger contacts. Find more power options in leads and connectors, and complete your build with AEG motors and pistons, cylinders and heads.